LANcube Software installation


Creative Commons License
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.

1.  Software installations and dependencies

1.1  Arduino IDE

You must first install IDE application on a computer with at least one USB port. In order to compile properly the arduino code you should verify in the Tools menu if you use:

  1. the Card type Arduino/Genuino Mega of Mega 2560
  2. the Processor Atmega2560 (Mega 2560)
  3. the correct comm port
  4. The Programmer AVR ISP

1.2  Installing LANcube software

You can download the latest software here:

LANcubeW-2019-10-09.inoBug fix for autogain when Lum=0
 Separate autogain per sensor

Older versions:

You will also need to install the following arduino libraries:

  1. Adafruit_Sensor-master
  2. Adafruit_TCS34725-master
  3. DHT_sensor_library
  4. DS1302
  5. RTClib-master
  6. TinyGPS-master

In order to get the LANcube time synchronized with the Greenwich Mean Time (GMT), it is important to set your computer time to GMT before uploading the software onto the arduino. If you want to reset that time, simply remove and put back the RTC battery and upload the software again.

GlossyBlue theme adapté par David Gilbert et Martin Aubé
Powered by PmWiki